Posted: February 7th, 2016

Fujiyama Electronics Case Study Part 2

This case study looks at the behavior of a circuit board process through the use of control charts. At least two control charts will need to be constructed, and from them, you will be asked to provide an assessment of what you see. A template to facilitate the construction of the control charts has been provided in Doc Sharing (Course Project—Part 2 Template.xlsx). You are not required to use this template; however, it will greatly facilitate the solution.

Problem Statement

Fujiyama Electronics Inc. has had difficulties with circuit boards purchased from an outside supplier. Unacceptable variability occurs between two drilled holes that are supposed to be 5 cm apart on the circuit boards. Thirty samples of four boards each were taken from shipments from the supplier. The data obtained can be found on a worksheet in Doc Sharing titled Fujiyama Electronics Sample Data or can be obtained by clicking here.